-
- News
- Books
Featured Books
- design007 Magazine
Latest Issues
Current IssueCreating a Culture of Collaboration
PCB designers could learn quite a bit from NASA and the private companies that develop spacecraft: Every one of these vehicles is a testament to the value of collaboration among disparate stakeholders. Without a collaborative culture, the rocket might never get off the ground.
Breaking High-speed Material Constraints
Do you need specialty materials for your high-speed designs? Maybe not. Improvements in resins mean designers of high-speed boards can sometimes use traditional laminate systems. Learn more in this issue.
Level Up Your Design Skills
This month, our contributors discuss the PCB design classes available at IPC APEX EXPO 2024. As they explain, these courses cover everything from the basics of design through avoiding over-constraining high-speed boards, and so much more!
- Articles
- Columns
Search Console
- Links
- Events
||| MENU - design007 Magazine
Estimated reading time: 1 minute
Beyond Design: The Dark Side–Return of the Signal
All PCB designers should be aware of the impact of crosstalk on signal integrity. As signal traces come into close proximity to an aggressor signal, part of that signal is unintentionally electromagnetically coupled into the victim trace as noise. I have mentioned before that current flow is a round trip—the current must return to the source to complete the loop. What about crosstalk in the return path of the reference planes as the current weaves its way back through the expansive wasteland of copper? This month’s column follows on from my April column, “Return Path Discontinuities,” and elaborates on crosstalk in the unseen “dark side” of the signal.
I guess we all think of a copper plane as a thick, solid plate of copper that can basically handle any amount of current we sink into it. It also serves to make the circuit layout easier, allowing the PCB designer to ground anything, anywhere without having to run multiple tracks. That may well be the case with DC or very low-frequency analog circuits, but certainly not in the case of high-speed design. The return current takes the path of least inductance in the nearest plane(s). Returning signal currents tend to stay in close proximity to their signal conductors, falling off in intensity with the square of increasing distance.
However, as the frequency increases, the current is forced into the outer surface of the copper, due to the skin effect, dramatically increasing loss leaving a section of unused copper in the center of the plane. This redistribution of current causes the resistance per length to increase and the loop inductance per length to decrease. As frequency increases beyond 1 GHz, the resistance continues to increase while the loop inductance reaches a limiting value. The higher the frequency, the greater the tendency for current to flow in the outer surface of the conductor.
To read this entire column, which appeared in the May 2017 issue of The PCB Design Magazine, click here.
More Columns from Beyond Design
Beyond Design: Dielectric Material Selection GuideBeyond Design: The Art of Presenting PCB Design Courses
Beyond Design: Embedded Capacitance Material
Beyond Design: Return Path Optimization
Beyond Design: Just a Matter of Time
Beyond Design: Design Success with IPC Standards
Beyond Design: Integrating AI Into PCB Design Flow
Beyond Design: Standing Waves in Multilayer PCB Plane Cavities